Sap Sale Module: RE:[sap-log-sd] variant configuration problem

Posted by Typewriter
on Jun 9 at 5:56 AM

Hi Vinny,

Below, I have mentioned the 2 ways, I have achieved the requirement.

Do you have any other ways? (Maybe you have achieved it with dependencies...)

Basically, if there are improvements to my ways or other better ways, then please share.

Regards,
Typewriter

*
1. One way - as mentioned before - was to give 700 - 70 = 630Euros, in VK11. Here the discount is not that clearly visible to the user in the sales order.
2. Another way - after talking with an expert - is as follows -
In VK11, give in condition type VA00 for values for GREY, 100CC, 120CC. & have new condition type ZVA0 for value for BLACK
Make new discount condition type ZVA1, give discount percentage for BLACK, in VK11
In pricing procedure, for ZVA1 refer Step no. of ZVA0. Then the requirement is met!

---------------Original Message---------------
From: Typewriter
Sent: Wednesday, June 08, 2011 1:59 PM
Subject: variant configuration problem

Hi Srikant,
Either I am not understanding your suggestion or you are not understanding my requirement.

Requirement is -
Material = BIKE, characteristics = COLOR & ENGINE
Values -
for COLOR = BLACK, GREY
for ENGINE = 100CC, 120CC
So, configurable material - BIKE - could be -
BLACK, 100CC; or BLACK, 120CC; or GREY, 100CC; or GREY, 120CC
Prices -
BLACK = 700Euros, GREY = 550Euros; 100CC = 1200Euros, 120CC = 1500Euros
Additional condition i.e. DISCOUNT -
If you buy BLACK, you get discount of 10% of BLACK (i.e. 70Euros). This discount is only for BLACK.
The above requirement must be satisfied. & in the sales order condition tab, the discount must be visible. In VK11, the user must be able to give this discount percentage.

I have got the below solution, trying to go around "Syntax" route -
1. One way - as mentioned before - was to give 700 - 70 = 630Euros, in VK11. Here the discount is not that clearly visible to the user in the sales order.
2. Another way - after talking with an expert - is as follows -
In VK11, give in condition type VA00 for values for GREY, 100CC, 120CC. & have new condition type ZVA0 for value for BLACK
Make new discount condition type ZVA1, give discount percentage for BLACK, in VK11
In pricing procedure, for ZVA1 refer Step no. of ZVA0. Then the requirement is met!

Please advice, if there could be improvements or better solutions.

__.____._