Sap Sale Module: RE:[sap-log-sd] Reference condition type

Posted by lakksh
on Jun 27 at 11:02 AM

Thank you very much. I was bale to make this work

---------------Original Message---------------
From: Typewriter
Sent: Saturday, June 25, 2011 5:41 PM
Subject: Reference condition type

I think, you have to create ZPR0 in SD module (i.e. with V/06), then in cond type PB00, the RefApplication field accept V (currently defaulting to M)

I think, this is not caused by access seq.

I have tested this by doing the following - (it is a "round about" way to test it, as I do not know how to create cond types in MM module)

In SD, in V/06 I created PR00, when I give field "RefConType" = PR00 & RefApplication = M (INSTEAD OF THE NORMAL = V)
I get below error -
Entry A M PR00 does not exist in T685 (check entry)

Because PR00 was created for V, therefore there is NO entry in T685. If I had created for M then there would have been an entry in T685.

-
Please explain how you created the cond types, pricing process; if it is different from doing it in SD.
-
Maybe Naughtybudgei can give some suggestions.
-
Maybe you might want to post this in the MM Forum too.

__.____._